Move some board specific functions to sb800.h.

Signed-off-by: Zheng Bao <zheng.bao@amd.com>
Acked-by: Zheng Bao <zheng.bao@amd.com>
git-svn-id: svn://svn.coreboot.org/coreboot/trunk@6279 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1

diff --git a/src/southbridge/amd/sb800/early_setup.c b/src/southbridge/amd/sb800/early_setup.c
index 61a0e665888c4faf993b76ed2b2b4154d21542a3..e9325043b5922e43c8b250b21ec5bcb4b3e2bf67 100644 (file)
--- a/src/southbridge/amd/sb800/early_setup.c
+++ b/src/southbridge/amd/sb800/early_setup.c
@@ -61,7 +61,7 @@ static void sb800_acpi_init(void) {
        pmio_write(0x6C, ACPI_PMA_CNT_BLK & 0xFF);
        pmio_write(0x6D, ACPI_PMA_CNT_BLK >> 8);
 
-       pm_iowrite(0x74, 1<<0 | 1<<1 | 1<<4 | 1<<2); /* AcpiDecodeEnable, When set, SB uses
+       pmio_write(0x74, 1<<0 | 1<<1 | 1<<4 | 1<<2); /* AcpiDecodeEnable, When set, SB uses
                                        * the contents of the PM registers at
                                        * index 60-6B to decode ACPI I/O address.
                                        * AcpiSmiEn & SmiCmdEn*/
@@ -95,8 +95,7 @@ static u8 get_sb800_revision(void)
        return rev;
 }
 
-#if 0
-static void sb800_clk_output_48Mhz(void)
+void sb800_clk_output_48Mhz(void)
 {
        /* AcpiMMioDecodeEn */
        u8 reg8;
@@ -108,7 +107,6 @@ static void sb800_clk_output_48Mhz(void)
        *(volatile u32 *)(0xFED80000+0xE00+0x40) &= ~((1 << 0) | (1 << 2)); /* 48Mhz */
        *(volatile u32 *)(0xFED80000+0xE00+0x40) |= 1 << 1; /* 48Mhz */
 }
-#endif
 /***************************************
 * Legacy devices are mapped to LPC space.
 *      Serial port 0
@@ -234,8 +232,7 @@ void soft_reset(void)
        outb(0x06, 0x0cf9);
 }
 
-#if 0
-static void sb800_pci_port80(void)
+void sb800_pci_port80(void)
 {
        u8 byte;
        device_t dev;
@@ -279,7 +276,7 @@ static void sb800_pci_port80(void)
        byte &= ~(1 << 5);      /* disable lpc port 80 */
        pci_write_config8(dev, 0x4A, byte);
 }
-#endif
+
 #define BIT0   (1 << 0)
 #define BIT1   (1 << 1)
 #define BIT2   (1 << 2)
@@ -296,54 +293,52 @@ struct pm_entry {
 };
 struct pm_entry const pm_table[] =
 {
-  {0x5D, 0x00, BIT0},
-  {0xD2, 0xCF, BIT4 + BIT5},
-  {0x12, 0x00, BIT0},
-  {0x28, 0xFF, BIT0},
-  {0x44 + 3, 0x7F, BIT7},
-  {0x48, 0xFF, BIT0},
-  {0x00, 0xFF, 0x0E},
-  {0x00 + 2, 0xFF, 0x40},
-  {0x00 + 3, 0xFF, 0x08},
-  {0x34, 0xEF, BIT0 + BIT1},
-  {0xEC, 0xFD, BIT1},
-  {0x5B, 0xF9, BIT1 + BIT2},
-  {0x08, 0xFE, BIT2 + BIT4},
-  {0x08 + 1, 0xFF, BIT0},
-  {0x54, 0x00, BIT4 + BIT7},
-  {0x04 + 3, 0xFD, BIT1},
-  {0x74, 0xF6, BIT0 + BIT3},
-  {0xF0, ~BIT2, 0x00},
-  {0xF8,     0x00, 0x6C},
-  {0xF8 + 1, 0x00, 0x27},
-  {0xF8 + 2, 0x00, 0x00},
-  {0xC4, 0xFE, 0x14},
-  {0xC0 + 2, 0xBF, 0x40},
-  {0xBE, 0xDD, BIT5},
-  // HPET workaround
-  {0x54 + 3, 0xFC, BIT0 + BIT1},
-  {0x54 + 2, 0x7F, BIT7},
-  {0x54 + 2, 0x7F, 0x00},
-  {0xC4, ~(BIT2 + BIT4), BIT2 + BIT4},
-  {0xC0, 0, 0xF9},
-  {0xC0 + 1, 0x04, 0x03},
-  {0xC2, 0x20, 0x58},
-  {0xC2 + 1, 0, 0x40},
-  {0xC2, ~(BIT4), BIT4},
-  {0x74, 0x00, BIT0 + BIT1 + BIT2 + BIT4},
-  {0xDE + 1, ~(BIT0 + BIT1), BIT0 + BIT1},
-  {0xDE, ~BIT4, BIT4},
-  {0xBA, ~BIT3, BIT3},
-  {0xBA + 1, ~BIT6, BIT6},
-  {0xBC, ~BIT1, BIT1},
-  {0xED, ~(BIT0 + BIT1), 0},
-  {0xDC, 0x7C, BIT0},
-
+       {0x5D, 0x00, BIT0},
+       {0xD2, 0xCF, BIT4 + BIT5},
+       {0x12, 0x00, BIT0},
+       {0x28, 0xFF, BIT0},
+       {0x44 + 3, 0x7F, BIT7},
+       {0x48, 0xFF, BIT0},
+       {0x00, 0xFF, 0x0E},
+       {0x00 + 2, 0xFF, 0x40},
+       {0x00 + 3, 0xFF, 0x08},
+       {0x34, 0xEF, BIT0 + BIT1},
+       {0xEC, 0xFD, BIT1},
+       {0x5B, 0xF9, BIT1 + BIT2},
+       {0x08, 0xFE, BIT2 + BIT4},
+       {0x08 + 1, 0xFF, BIT0},
+       {0x54, 0x00, BIT4 + BIT7},
+       {0x04 + 3, 0xFD, BIT1},
+       {0x74, 0xF6, BIT0 + BIT3},
+       {0xF0, ~BIT2, 0x00},
+       {0xF8,     0x00, 0x6C},
+       {0xF8 + 1, 0x00, 0x27},
+       {0xF8 + 2, 0x00, 0x00},
+       {0xC4, 0xFE, 0x14},
+       {0xC0 + 2, 0xBF, 0x40},
+       {0xBE, 0xDD, BIT5},
+       // HPET workaround
+       {0x54 + 3, 0xFC, BIT0 + BIT1},
+       {0x54 + 2, 0x7F, BIT7},
+       {0x54 + 2, 0x7F, 0x00},
+       {0xC4, ~(BIT2 + BIT4), BIT2 + BIT4},
+       {0xC0, 0, 0xF9},
+       {0xC0 + 1, 0x04, 0x03},
+       {0xC2, 0x20, 0x58},
+       {0xC2 + 1, 0, 0x40},
+       {0xC2, ~(BIT4), BIT4},
+       {0x74, 0x00, BIT0 + BIT1 + BIT2 + BIT4},
+       {0xDE + 1, ~(BIT0 + BIT1), BIT0 + BIT1},
+       {0xDE, ~BIT4, BIT4},
+       {0xBA, ~BIT3, BIT3},
+       {0xBA + 1, ~BIT6, BIT6},
+       {0xBC, ~BIT1, BIT1},
+       {0xED, ~(BIT0 + BIT1), 0},
+       {0xDC, 0x7C, BIT0},
 //  {0xFF, 0xFF, 0xFF},
-  
 };
 
-static void sb800_lpc_port80(void)
+void sb800_lpc_port80(void)
 {
        u8 byte;
        device_t dev;

diff --git a/src/southbridge/amd/sb800/sb800.h b/src/southbridge/amd/sb800/sb800.h
index 80578c1232184c0ba95459156c0c52c4b9d67ea3..870e36ad97b26b453da12da65d61cd269c294c26 100644 (file)
--- a/src/southbridge/amd/sb800/sb800.h
+++ b/src/southbridge/amd/sb800/sb800.h
@@ -47,12 +47,13 @@ extern void set_sm_enable_bits(device_t sm_dev, u32 reg_pos, u32 mask, u32 val);
 #define REV_SB800_A11  0x11
 #define REV_SB800_A12  0x12
 
-/* This shouldn't be called before set_sb800_revision() is called.
- * Once set_sb800_revision() is called, we use get_sb800_revision(),
- * the simpler one, to get the sb800 revision ID.
- * The id is 0x39 if A11, 0x3A if A12, 0x3C if A14, 0x3D if A15.
- * The differentiate is 0x28, isn't it? */
-//#define get_sb800_revision(sm_dev)   (pci_read_config8((sm_dev), 0x08) - 0x28)
+#ifdef __PRE_RAM__
+void sb800_lpc_port80(void);
+void sb800_pci_port80(void);
+void sb800_clk_output_48Mhz(void);
+#else
+/* void sb800_setup_sata_phys(struct device *dev); */
+#endif
 
 void sb800_enable(device_t dev);
 void sb800_enable_usbdebug(unsigned int port);