Signed-off-by: Peter Stuge <peter@stuge.se>
Acked-by: Peter Stuge <peter@stuge.se>
git-svn-id: svn://svn.coreboot.org/coreboot/trunk@4141
2b7e53f0-3cfb-0310-b3e9-
8179ed1497e1
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
-Flashrom is a utility for reading, writing, and erasing flash ROM chips.
+flashrom is a utility for reading, writing, and erasing flash ROM chips.
It's often used to flash BIOS/coreboot/firmware images.
It supports a wide range of DIP32, PLCC32, DIP8, SO8/SOIC8, TSOP32, and
It's often used to flash BIOS/coreboot/firmware images.
It supports a wide range of DIP32, PLCC32, DIP8, SO8/SOIC8, TSOP32, and
-Flashrom exits with 0 on success, 1 on most failures but with 2 if /dev/mem
+flashrom exits with 0 on success, 1 on most failures but with 2 if /dev/mem
(/dev/xsvc on Solaris) can not be opened and with 3 if a call to mmap() fails.
coreboot Table and Mainboard Identification
--------------------------------------------
(/dev/xsvc on Solaris) can not be opened and with 3 if a call to mmap() fails.
coreboot Table and Mainboard Identification
--------------------------------------------
-Flashrom reads the coreboot table to determine the current mainboard. If no
+flashrom reads the coreboot table to determine the current mainboard. If no
coreboot table could be read or if you want to override these values, you can
specify -m, e.g.:
coreboot table could be read or if you want to override these values, you can
specify -m, e.g.:
ROM Layout Support
------------------
ROM Layout Support
------------------
-Flashrom supports ROM layouts. This allows you to flash certain parts of
+flashrom supports ROM layouts. This allows you to flash certain parts of
the flash chip only. A ROM layout file looks like follows:
00000000:00008fff gfxrom
the flash chip only. A ROM layout file looks like follows:
00000000:00008fff gfxrom