3 #include <device/pci_def.h>
5 #include <device/pnp_def.h>
6 #include <arch/romcc_io.h>
7 #include <cpu/x86/lapic.h>
8 #include <pc80/mc146818rtc.h>
9 #include <console/console.h>
12 #include <cpu/amd/model_fxx_rev.h>
13 #include "northbridge/amd/amdk8/incoherent_ht.c"
14 #include "southbridge/amd/amd8111/amd8111_early_smbus.c"
15 #include "northbridge/amd/amdk8/raminit.h"
16 #include "cpu/amd/model_fxx/apic_timer.c"
17 #include "lib/delay.c"
18 #include "cpu/x86/lapic/boot_cpu.c"
19 #include "northbridge/amd/amdk8/reset_test.c"
20 #include "northbridge/amd/amdk8/debug.c"
21 #include "superio/winbond/w83627hf/w83627hf_early_serial.c"
22 #include "cpu/x86/mtrr/earlymtrr.c"
23 #include "cpu/x86/bist.h"
24 #include "northbridge/amd/amdk8/setup_resource_map.c"
25 #include "southbridge/amd/amd8111/amd8111_early_ctrl.c"
27 #define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
29 static void memreset_setup(void)
32 outb((1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 16); //REVC_MEMRST_EN=0
34 outb((1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 16); //REVC_MEMRST_EN=1
35 outb((1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 17);
38 static void memreset(int controllers, const struct mem_controller *ctrl)
40 if (is_cpu_pre_c0()) {
42 outb((1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 17); //REVB_MEMRST_L=1
47 static void activate_spd_rom(const struct mem_controller *ctrl) { }
49 static inline int spd_read_byte(unsigned device, unsigned address)
51 return smbus_read_byte(device, address);
54 #include "northbridge/amd/amdk8/raminit.c"
55 #include "resourcemap.c"
56 #include "northbridge/amd/amdk8/coherent_ht.c"
57 #include "lib/generic_sdram.c"
58 #include "cpu/amd/dualcore/dualcore.c"
59 #include "cpu/amd/car/post_cache_as_ram.c"
60 #include "cpu/amd/model_fxx/init_cpus.c"
61 #include "southbridge/amd/amd8111/amd8111_enable_rom.c"
62 #include "northbridge/amd/amdk8/early_ht.c"
64 void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
66 static const uint16_t spd_addr [] = {
69 #if CONFIG_MAX_PHYSICAL_CPUS > 1
76 unsigned bsp_apicid = 0, nodes;
77 struct mem_controller ctrl[8];
79 if (!cpu_init_detectedx && boot_cpu()) {
80 /* Nothing special needs to be done to find bus 0 */
81 /* Allow the HT devices to be found */
87 bsp_apicid = init_cpus(cpu_init_detectedx);
91 w83627hf_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
95 /* Halt if there was a built in self test failure */
96 report_bist_failure(bist);
98 setup_s2881_resource_map();
100 dump_pci_device(PCI_DEV(0, 0x18, 0));
101 dump_pci_device(PCI_DEV(0, 0x19, 0));
104 needs_reset = setup_coherent_ht_domain();
106 wait_all_core0_started();
107 #if CONFIG_LOGICAL_CPUS==1
108 // It is said that we should start core1 after all core0 launched
110 wait_all_other_cores_started(bsp_apicid);
113 needs_reset |= ht_setup_chains_x();
116 print_info("ht reset -\n");
122 dump_spd_registers(&cpu[0]);
123 dump_smbus_registers();
126 allow_all_aps_stop(bsp_apicid);
129 //It's the time to set ctrl now;
130 fill_mem_ctrl(nodes, ctrl, spd_addr);
133 sdram_initialize(nodes, ctrl);