Use DIMM0 et al in lots more places instead of hardocding values.
[coreboot.git] / src / mainboard / arima / hdama / romstage.c
1 #include <stdint.h>
2 #include <string.h>
3 #include <device/pci_def.h>
4 #include <arch/io.h>
5 #include <device/pnp_def.h>
6 #include <arch/romcc_io.h>
7 #include <cpu/x86/lapic.h>
8 #include <pc80/mc146818rtc.h>
9 #include <console/console.h>
10
11 #include <cpu/amd/model_fxx_rev.h>
12 #include "northbridge/amd/amdk8/incoherent_ht.c"
13 #include "southbridge/amd/amd8111/amd8111_early_smbus.c"
14 #include "northbridge/amd/amdk8/raminit.h"
15 #include "cpu/amd/model_fxx/apic_timer.c"
16 #include "lib/delay.c"
17
18 #include "cpu/x86/lapic/boot_cpu.c"
19 #include "northbridge/amd/amdk8/reset_test.c"
20 #include "northbridge/amd/amdk8/debug.c"
21 #include "superio/nsc/pc87360/pc87360_early_serial.c"
22
23 #include "cpu/x86/mtrr/earlymtrr.c"
24 #include "cpu/x86/bist.h"
25
26 #include "northbridge/amd/amdk8/setup_resource_map.c"
27 #include <spd.h>
28
29 #define SERIAL_DEV PNP_DEV(0x2e, PC87360_SP1)
30
31 #include "southbridge/amd/amd8111/amd8111_early_ctrl.c"
32
33 /*
34  * GPIO28 of 8111 will control H0_MEMRESET_L
35  * GPIO29 of 8111 will control H1_MEMRESET_L
36  */
37 static void memreset_setup(void)
38 {
39         if (is_cpu_pre_c0()) {
40                 /* Set the memreset low */
41                 outb((0 << 7)|(0 << 6)|(0<<5)|(0<<4)|(1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 28);
42                 /* Ensure the BIOS has control of the memory lines */
43                 outb((0 << 7)|(0 << 6)|(0<<5)|(0<<4)|(1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 29);
44         }
45         else {
46                 /* Ensure the CPU has controll of the memory lines */
47                 outb((0 << 7)|(0 << 6)|(0<<5)|(0<<4)|(1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 29);
48         }
49 }
50
51 static void memreset(int controllers, const struct mem_controller *ctrl)
52 {
53         if (is_cpu_pre_c0()) {
54                 udelay(800);
55                 /* Set memreset_high */
56                 outb((0<<7)|(0<<6)|(0<<5)|(0<<4)|(1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 28);
57                 udelay(90);
58         }
59 }
60
61 static inline void activate_spd_rom(const struct mem_controller *ctrl)
62 {
63         /* nothing to do */
64 }
65
66 static inline int spd_read_byte(unsigned device, unsigned address)
67 {
68         return smbus_read_byte(device, address);
69 }
70
71
72 #include "northbridge/amd/amdk8/raminit.c"
73 #include "northbridge/amd/amdk8/resourcemap.c"
74 #include "northbridge/amd/amdk8/coherent_ht.c"
75 #include "lib/generic_sdram.c"
76
77 #include "cpu/amd/dualcore/dualcore.c"
78
79 #include "cpu/amd/car/post_cache_as_ram.c"
80
81 #include "cpu/amd/model_fxx/init_cpus.c"
82
83 #include "southbridge/amd/amd8111/amd8111_enable_rom.c"
84 #include "northbridge/amd/amdk8/early_ht.c"
85
86 void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
87 {
88         static const uint16_t spd_addr [] = {
89                 DIMM0, DIMM2, 0, 0,
90                 DIMM1, DIMM3, 0, 0,
91 #if CONFIG_MAX_PHYSICAL_CPUS > 1
92                 DIMM4, DIMM6, 0, 0,
93                 DIMM5, DIMM7, 0, 0,
94 #endif
95         };
96
97         int needs_reset;
98         unsigned bsp_apicid = 0;
99         struct mem_controller ctrl[8];
100         unsigned nodes;
101
102         if (!cpu_init_detectedx && boot_cpu()) {
103                 /* Nothing special needs to be done to find bus 0 */
104                 /* Allow the HT devices to be found */
105
106                 enumerate_ht_chain();
107
108                 amd8111_enable_rom();
109         }
110
111         if (bist == 0) {
112                 bsp_apicid = init_cpus(cpu_init_detectedx);
113         }
114
115         pc87360_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
116         uart_init();
117         console_init();
118
119         /* Halt if there was a built in self test failure */
120         report_bist_failure(bist);
121
122         setup_default_resource_map();
123
124         needs_reset = setup_coherent_ht_domain();
125
126 #if CONFIG_LOGICAL_CPUS==1
127         // It is said that we should start core1 after all core0 launched
128         start_other_cores();
129         wait_all_other_cores_started(bsp_apicid);
130 #endif
131         /* This is needed to be able to call udelay().  It could be moved to
132          * memreset_setup, since udelay is called in memreset. */
133         init_timer();
134
135         // automatically set that for you, but you might meet tight space
136         needs_reset |= ht_setup_chains_x();
137
138         if (needs_reset) {
139                 print_info("ht reset -\n");
140                 soft_reset();
141         }
142
143         allow_all_aps_stop(bsp_apicid);
144
145         nodes = get_nodes();
146
147         fill_mem_ctrl(nodes, ctrl, spd_addr);
148
149         enable_smbus();
150
151         memreset_setup();
152
153         sdram_initialize(nodes, ctrl);
154
155         post_cache_as_ram();
156 }
157