+#ifndef __CONFIG_H
+#define __CONFIG_H
+
// Configuration definitions.
+//#define CONFIG_APPNAME "QEMU"
+//#define CONFIG_CPUNAME8 "QEMUCPU "
+//#define CONFIG_APPNAME6 "QEMU "
+//#define CONFIG_APPNAME4 "QEMU"
+#define CONFIG_APPNAME "Bochs"
+#define CONFIG_CPUNAME8 "BOCHSCPU"
+#define CONFIG_APPNAME6 "BOCHS "
+#define CONFIG_APPNAME4 "BXPC"
+
+// Configure for use with KVM.
+#define CONFIG_KVM 0
+// Configure as a coreboot payload.
+#define CONFIG_COREBOOT 0
+
+// Control how verbose debug output is.
+#define CONFIG_DEBUG_LEVEL 1
+
+// Send debugging information to serial port
+#define CONFIG_DEBUG_SERIAL 0
+
+// Support for int13 floppy drive access
#define CONFIG_FLOPPY_SUPPORT 1
-#define CONFIG_PS2_MOUSE 0
-#define CONFIG_ATA 0
-#define CONFIG_STACK16_SEGMENT 0x00
-#define CONFIG_STACK16_OFFSET 0xfffe
-#define CONFIG_STACK32_OFFSET 0x80000
+// Support for int15c2 mouse calls
+#define CONFIG_PS2_MOUSE 1
+// Support for IDE disk code
+#define CONFIG_ATA 1
+// Support calling int155f on each keyboard event
+#define CONFIG_KBD_CALL_INT15_4F 1
+// Support for booting from a CD
+#define CONFIG_CDROM_BOOT 1
+// Support for emulating a boot CD as a floppy/harddrive
+#define CONFIG_CDROM_EMU 1
+// Support int 1a/b1 PCI BIOS calls
+#define CONFIG_PCIBIOS 1
+// Support int 15/53 APM BIOS calls
+#define CONFIG_APMBIOS 1
+// Support PnP BIOS entry point.
+#define CONFIG_PNPBIOS 1
+// Support int 19/18 system bootup support
+#define CONFIG_BOOT 1
+// Support int 14 serial port calls
+#define CONFIG_SERIAL 1
+// Support int 17 parallel port calls
+#define CONFIG_LPT 1
+// Support int 16 keyboard calls
+#define CONFIG_KEYBOARD 1
+// Support finding and running option roms during post.
+#define CONFIG_OPTIONROMS 1
+// Set if option roms are already copied to 0xc0000-0xf0000
+#define CONFIG_OPTIONROMS_DEPLOYED 1
+// When option roms are not pre-deployed, SeaBIOS can copy an optionrom
+// from flash for up to 2 devices.
+#define OPTIONROM_BDF_1 0x0000
+#define OPTIONROM_MEM_1 0x00000000
+#define OPTIONROM_BDF_2 0x0000
+#define OPTIONROM_MEM_2 0x00000000
+// Support an interactive boot menu at end of post.
+#define CONFIG_BOOTMENU 1
+
+// Support generation of a PIR table in 0xf000 segment (for emulators)
+#define CONFIG_PIRTABLE 1
+// Support generation of MPTable (for emulators)
+#define CONFIG_MPTABLE 1
+// Support generation of SM BIOS tables (for emulators)
+#define CONFIG_SMBIOS 1
+// Support finding a UUID (for smbios) via "magic" outl sequence.
+#define CONFIG_UUID_BACKDOOR 1
+// Support generation of ACPI tables (for emulators)
+#define CONFIG_ACPI 1
+// Support bios callbacks specific to via vgabios.
+#define CONFIG_VGAHOOKS 0
+// Maximum number of map entries in the e820 map
+#define CONFIG_MAX_E820 32
+
+/* define it if the (emulated) hardware supports SMM mode */
+#define CONFIG_USE_SMM 1
+
+#define CONFIG_MAX_ATA_INTERFACES 4
+#define CONFIG_MAX_ATA_DEVICES (CONFIG_MAX_ATA_INTERFACES*2)
+
+#define CONFIG_ACPI_DATA_SIZE 0x00010000L
+
+#define CONFIG_MODEL_ID 0xFC
+#define CONFIG_SUBMODEL_ID 0x00
+#define CONFIG_BIOS_REVISION 0x01
+
+// Various memory addresses used by the code.
+#define BUILD_STACK_ADDR 0x7c00
+#define BUILD_S3RESUME_STACK_ADDR 0x1000
+#define BUILD_AP_BOOT_ADDR 0x10000
+#define BUILD_BIOS_ADDR 0xf0000
+#define BUILD_BIOS_SIZE 0x10000
+// 64 KB used to copy the BIOS to shadow RAM
+#define BUILD_BIOS_TMP_ADDR 0x30000
+
+#define BUILD_APIC_ADDR 0xfee00000
+#define BUILD_IOAPIC_ADDR 0xfec00000
+
+#define BUILD_SMM_INIT_ADDR 0x38000
+#define BUILD_SMM_ADDR 0xa8000
+#define BUILD_SMM_SIZE 0x8000
+
+// Important real-mode segments
+#define SEG_IVT 0x0000
+#define SEG_BDA 0x0040
+#define SEG_BIOS 0xf000
+
+// Segment definitions in protected mode (see rombios32_gdt in romlayout.S)
+#define SEG32_MODE32_CS (2 << 3)
+#define SEG32_MODE32_DS (3 << 3)
+#define SEG32_MODE16_CS (4 << 3)
+#define SEG32_MODE16_DS (5 << 3)
+#define SEG32_MODE16BIG_CS (6 << 3)
+#define SEG32_MODE16BIG_DS (7 << 3)
+
+// Debugging levels. If non-zero and CONFIG_DEBUG_LEVEL is greater
+// than the specified value, then the corresponding irq handler will
+// report every enter event.
+#define DEBUG_ISR_nmi 1
+#define DEBUG_HDL_05 1
+#define DEBUG_ISR_08 20
+#define DEBUG_ISR_09 9
+#define DEBUG_ISR_0e 9
+#define DEBUG_HDL_10 20
+#define DEBUG_HDL_11 1
+#define DEBUG_HDL_12 1
+#define DEBUG_HDL_13 10
+#define DEBUG_HDL_14 1
+#define DEBUG_HDL_15 9
+#define DEBUG_HDL_16 9
+#define DEBUG_HDL_17 1
+#define DEBUG_HDL_18 1
+#define DEBUG_HDL_19 1
+#define DEBUG_HDL_1a 9
+#define DEBUG_ISR_1c 20
+#define DEBUG_HDL_40 1
+#define DEBUG_ISR_70 9
+#define DEBUG_ISR_74 9
+#define DEBUG_ISR_75 1
+#define DEBUG_ISR_76 10
+#define DEBUG_ISR_hwpic1 1
+#define DEBUG_ISR_hwpic2 1
+#define DEBUG_HDL_pnp 1
+
+#endif // config.h
projects / seabios.git / blobdiff