+define K8_REV_F_SUPPORT
+ default 0
+ export always
+ comment "Opteron Rev F (DDR2) support"
+end
+
+define CBB
+ default 0
+ export always
+ comment "Opteron cpu bus num base"
+end
+
+define CDB
+ default 0x18
+ export always
+ comment "Opteron cpu device num base"
+end
+
+define HT3_SUPPORT
+ default 0
+ export always
+ comment "Hypertransport 3 support, include ac HT and unganged sublink feature"
+end
+
+define EXT_RT_TBL_SUPPORT
+ default 0
+ export always
+ comment "support AMD family 10 extended routing table via F0x158, normally is enabled when node nums is greater than 8"
+end
+
+define EXT_CONF_SUPPORT
+ default 0
+ export always
+ comment "support AMD family 10 extended config space for ram, bus, io, mmio via F1x110, normally is enabled when HT3 is enabled and non ht chain nums is greater than 4"
+end
+
+define DIMM_SUPPORT
+ default 0x0108
+ format "0x%x"
+ export always
+ comment "DIMM support: bit 0 - sdram, bit 1: ddr1, bit 2: ddr2, bit 3: ddr3, bit 4: fbdimm, bit 8: reg"
+end
+
+define CPU_SOCKET_TYPE
+ default 0x10
+ export always
+ comment "cpu socket type, 0x10 mean Socket F, 0x11 mean socket M2, 0x20, Soxket G, and 0x21 mean socket M3"
+end
+
+define CPU_ADDR_BITS
+ default 36
+ export always
+ comment "CPU hardware address lines num, for AMD K8 could be 40, and AMD family 10 could be 48"
+end
+
+define CONFIG_VGA_ROM_RUN
+ default 0
+ export always
+ comment "Init x86 ROMs on VGA-class PCI devices"
+end
+