# Settings section
# You probably want to customize those
##############################################################################
-TARGET=arm-none-eabi # Or: TARGET=arm-elf
-PREFIX=${HOME}/arm-none-eabi # Install location of your final toolchain
+TARGET=arm-elf # Or: TARGET=arm-elf
+PREFIX=/arm # Install location of your final toolchain
PARALLEL= # Or: PARALLEL="-j 5" for 4 CPUs
DARWIN_OPT_PATH=/opt/local # Path in which MacPorts or Fink is installed
# Set to 'sudo' if you need superuser privileges while installing
-SUDO=
+SUDO='sudo'
# Set to 1 to be quieter while running
QUIET=0
# Set to 1 to use linaro gcc instead of the FSF gcc
-USE_LINARO=0
+USE_LINARO=1
# Set to 1 to build libstm32 provided by ST
LIBSTM32_EN=0
# Set to 1 to build libopenstm32 an open source library for stm32
;;
Darwin)
echo "Found Darwin OS."
- GCCFLAGS="${GCCFLAGS} \
- --with-gmp=${DARWIN_OPT_PATH} \
+
+ # darwin dependencies
+ DARWINDEPS="gnutar mpfr libmpc gmp"
+ DARWINDEPSCOUNT=4
+
+ GCCFLAGS="${GCCFLAGS} \
+ --with-gmp=${DARWIN_OPT_PATH} \
--with-mpfr=${DARWIN_OPT_PATH} \
--with-mpc=${DARWIN_OPT_PATH} \
- -with-libiconv-prefix=${DARWIN_OPT_PATH}"
- if ! which gnutar > /dev/null ; then
- echo "ERROR: GNU tar not found! (try 'sudo port install gnutar')"
- exit 1
- else
- echo "GNU tar found!"
- TAR=gnutar
- fi
+ -with-libiconv-prefix=${DARWIN_OPT_PATH}"
+
+ echo "Attempting to automatically check if common dependencies are installed on your system"
+ if ! which port > /dev/null; then
+ echo "MacPorts not installed."
+ else
+ pc=`port installed ${DARWINDEPS} | wc -l | tr -d " "`
+ if [ ${pc} -lt $[{DARWINDEPSCOUNT}+1] ];
+ then
+ echo "Something is missing, do you want to install everything needed?"
+ echo "(You need super user rights to do this.)"
+
+ if [ read = "y" || read = "yes" ];
+ then
+ sudo port install ${DARWINDEPS}
+ fi
+ else
+ echo "Found: "${DARWINDEPS}"!"
+ fi
+ fi
+
+ TAR=gnutar
+
;;
+
*)
echo "Found unknown OS. Aborting!"
exit 1
# Unpack an archive
function unpack {
log Unpacking $*
- # Use 'auto' mode decompression. Replace with a switch if tar doesn't support -a
- ${TAR} xaf${TARFLAGS} ${SOURCES}/$1.tar.*
+ if [ -f ${SOURCES}/$1.tar.gz ];
+ then
+ ${TAR} xfz${TARFLAGS} ${SOURCES}/$1.tar.gz
+ else
+ ${TAR} xfj${TARFLAGS} ${SOURCES}/$1.tar.bz2
+ fi
}
# Install a build