dst_link = (config_map >> 8) & 3;
bus_base = (config_map >> 16) & 0xff;
#if 0
- printk_debug("node.link=bus: %d.%d=%d 0x%2x->0x%08x\n",
+ printk(BIOS_DEBUG, "node.link=bus: %d.%d=%d 0x%2x->0x%08x\n",
dst_node, dst_link, bus_base,
reg, config_map);
#endif
/* HT chain 0 */
bus_chain_0 = node_link_to_bus(0, 0);
if (bus_chain_0 == 0xff) {
- printk_debug("ERROR - cound not find bus for node 0 chain 0, using defaults\n");
+ printk(BIOS_DEBUG, "ERROR - cound not find bus for node 0 chain 0, using defaults\n");
bus_chain_0 = 0;
}
bus_isa++;
}
else {
- printk_debug("ERROR - could not find PCI %02x:03.0, using defaults\n", bus_chain_0);
+ printk(BIOS_DEBUG, "ERROR - could not find PCI %02x:03.0, using defaults\n", bus_chain_0);
bus_8111_1 = 4;
bus_isa = 5;
}
else {
- printk_debug("ERROR - could not find PCI %02x:01.0, using defaults\n", bus_chain_0);
+ printk(BIOS_DEBUG, "ERROR - could not find PCI %02x:01.0, using defaults\n", bus_chain_0);
bus_8131_1 = 2;
}
}
else {
- printk_debug("ERROR - could not find PCI %02x:02.0, using defaults\n", bus_chain_0);
+ printk(BIOS_DEBUG, "ERROR - could not find PCI %02x:02.0, using defaults\n", bus_chain_0);
bus_8131_2 = 3;
}
/* Compute the checksums */
mc->mpe_checksum = smp_compute_checksum(smp_next_mpc_entry(mc), mc->mpe_length);
mc->mpc_checksum = smp_compute_checksum(mc, mc->mpc_length);
- printk_debug("Wrote the mp table end at: %p - %p\n",
+ printk(BIOS_DEBUG, "Wrote the mp table end at: %p - %p\n",
mc, smp_next_mpe_entry(mc));
return smp_next_mpe_entry(mc);
}
unsigned bus_chain_0 = node_link_to_bus(0, 0);
reset = 0;
- printk_debug("Looking for bad PCIX MHz input\n");
+ printk(BIOS_DEBUG, "Looking for bad PCIX MHz input\n");
dev = dev_find_slot(bus_chain_0, PCI_DEVFN(0x02,0));
if (!dev)
- printk_debug("Couldn't find %02x:02.0 \n", bus_chain_0);
+ printk(BIOS_DEBUG, "Couldn't find %02x:02.0 \n", bus_chain_0);
else {
data = pci_read_config32(dev, 0xa0);
if(!(((data>>16)&0x03)==0x03)) {
reset=1;
- printk_debug("Bad PCIX MHz - Reset\n");
+ printk(BIOS_DEBUG, "Bad PCIX MHz - Reset\n");
}
}
- printk_debug("Looking for bad Hot Swap Enable\n");
+ printk(BIOS_DEBUG, "Looking for bad Hot Swap Enable\n");
dev = dev_find_slot(bus_chain_0, PCI_DEVFN(0x01,0));
if (!dev)
- printk_debug("Couldn't find %02x:01.0 \n", bus_chain_0);
+ printk(BIOS_DEBUG, "Couldn't find %02x:01.0 \n", bus_chain_0);
else {
data = pci_read_config32(dev, 0x48);
if(data & 0x0c) {
reset=1;
- printk_debug("Bad Hot Swap start - Reset\n");
+ printk(BIOS_DEBUG, "Bad Hot Swap start - Reset\n");
}
}
if(reset) {
outb(0x0e, 0x0cf9);
}
else {
- printk_debug("OK 133MHz & Hot Swap is off\n");
+ printk(BIOS_DEBUG, "OK 133MHz & Hot Swap is off\n");
}
}