X-Git-Url: http://wien.tomnetworks.com/gitweb/?a=blobdiff_plain;f=src%2Fsouthbridge%2Famd%2Fsb700%2Fsb700.h;h=165c72d52b24597bf42232e20a2641d12f9a7f23;hb=5ff7c13e858a31addf1558731a12cf6c753b576d;hp=72a6b202fe6db896969399d15fc0de95eecafdc9;hpb=3310934f32e683b6092b565773081434cba19ecf;p=coreboot.git

diff --git a/src/southbridge/amd/sb700/sb700.h b/src/southbridge/amd/sb700/sb700.h
index 72a6b202f..165c72d52 100644
--- a/src/southbridge/amd/sb700/sb700.h
+++ b/src/southbridge/amd/sb700/sb700.h
@@ -24,6 +24,8 @@
 #include "chip.h"
 
 /* Power management index/data registers */
+#define BIOSRAM_INDEX	0xcd4
+#define BIOSRAM_DATA	0xcd5
 #define PM_INDEX	0xcd6
 #define PM_DATA		0xcd7
 #define PM2_INDEX	0xcd0
@@ -33,7 +35,7 @@
 
 #define ACPI_PM_EVT_BLK		(SB700_ACPI_IO_BASE + 0x00) /* 4 bytes */
 #define ACPI_PM1_CNT_BLK	(SB700_ACPI_IO_BASE + 0x04) /* 2 bytes */
-#define ACPI_PMA_CNT_BLK	(SB700_ACPI_IO_BASE + 0x0F) /* 1 byte */
+#define ACPI_PMA_CNT_BLK	(SB700_ACPI_IO_BASE + 0x0E) /* 1 byte */
 #define ACPI_PM_TMR_BLK		(SB700_ACPI_IO_BASE + 0x18) /* 4 bytes */
 #define ACPI_GPE0_BLK		(SB700_ACPI_IO_BASE + 0x10) /* 8 bytes */
 #define ACPI_CPU_CONTROL	(SB700_ACPI_IO_BASE + 0x08) /* 6 bytes */
@@ -56,17 +58,30 @@ extern void set_sm_enable_bits(device_t sm_dev, u32 reg_pos, u32 mask, u32 val);
  * The differentiate is 0x28, isn't it? */
 #define get_sb700_revision(sm_dev)	(pci_read_config8((sm_dev), 0x08) - 0x28)
 
-void sb700_enable(device_t dev);
+void sb7xx_51xx_enable(device_t dev);
 
 #ifdef __PRE_RAM__
-void sb700_lpc_port80(void);
-void sb700_pci_port80(void);
+void sb7xx_51xx_lpc_port80(void);
+void sb7xx_51xx_pci_port80(void);
+void sb7xx_51xx_lpc_init(void);
+void sb7xx_51xx_enable_wideio(u8 wio_index, u16 base);
+void sb7xx_51xx_disable_wideio(u8 wio_index);
+void sb7xx_51xx_early_setup(void);
+void sb7xx_51xx_before_pci_init(void);
 #else
 #include <device/pci.h>
 /* allow override in mainboard.c */
-void sb700_setup_sata_phys(struct device *dev);
+void sb7xx_51xx_setup_sata_phys(struct device *dev);
 
 #endif
 
-void sb700_enable_usbdebug(unsigned int port);
+#if CONFIG_HAVE_ACPI_RESUME == 1
+int acpi_is_wakeup_early(void);
+#endif
+
+int s3_save_nvram_early(u32 dword, int size, int  nvram_pos);
+int s3_load_nvram_early(int size, u32 *old_dword, int nvram_pos);
+
+u32 __attribute__ ((weak)) get_sbdn(u32 bus);
+void __attribute__((weak)) enable_fid_change_on_sb(u32 sbbusn, u32 sbdn);
 #endif /* SB700_H */