* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
-#define ASSEMBLY 1
-#define __PRE_RAM__
-
#define RAMINIT_SYSINFO 1
#define FAM10_SCAN_PCI_BUS 0
#define SET_NB_CFG_54 1
#endif
-#define FAM10_SET_FIDVID 1
-#define FAM10_SET_FIDVID_CORE_RANGE 0
+#define SET_FIDVID 1
+#define SET_FIDVID_CORE_RANGE 0
#define DBGP_DEFAULT 7
#include <cpu/x86/lapic.h>
#include "option_table.h"
#include "pc80/mc146818rtc_early.c"
-
-static void post_code(u8 value) {
- outb(value, 0x80);
-}
-
-#if CONFIG_USE_FAILOVER_IMAGE==0
#include "pc80/serial.c"
-#include "arch/i386/lib/console.c"
+#include "console/console.c"
#if CONFIG_USBDEBUG_DIRECT
#include "southbridge/nvidia/mcp55/mcp55_enable_usbdebug_direct.c"
#include "pc80/usbdebug_direct_serial.c"
#include "northbridge/amd/amdfam10/raminit.h"
#include "northbridge/amd/amdfam10/amdfam10.h"
-#endif
-
#include "cpu/x86/lapic/boot_cpu.c"
#include "northbridge/amd/amdfam10/reset_test.c"
#include "superio/winbond/w83627hf/w83627hf_early_serial.c"
#include "superio/winbond/w83627hf/w83627hf_early_init.c"
-#if CONFIG_USE_FAILOVER_IMAGE==0
-
#include "cpu/x86/bist.h"
#include "northbridge/amd/amdfam10/debug.c"
-#include "cpu/amd/mtrr/amd_earlymtrr.c"
+#include "cpu/x86/mtrr/earlymtrr.c"
#include "northbridge/amd/amdfam10/setup_resource_map.c"
#include "southbridge/nvidia/mcp55/mcp55_early_ctrl.c"
-static void memreset_setup(void)
-{
-}
-
-static void memreset(int controllers, const struct mem_controller *ctrl)
-{
-}
-
static inline void activate_spd_rom(const struct mem_controller *ctrl)
{
/* nothing to do */
#include "southbridge/nvidia/mcp55/mcp55_early_setup_ss.h"
#include "southbridge/nvidia/mcp55/mcp55_early_setup_car.c"
-#include "cpu/amd/car/copy_and_run.c"
-
#include "cpu/amd/car/post_cache_as_ram.c"
+#include "cpu/amd/microcode/microcode.c"
+#include "cpu/amd/model_10xxx/update_microcode.c"
#include "cpu/amd/model_10xxx/init_cpus.c"
#include "cpu/amd/model_10xxx/fidvid.c"
-#endif
-
#include "southbridge/nvidia/mcp55/mcp55_enable_rom.c"
#include "northbridge/amd/amdfam10/early_ht.c"
static void sio_setup(void)
{
- unsigned value;
uint32_t dword;
uint8_t byte;
dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4);
dword |= (1<<16);
pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword);
-
}
-#if CONFIG_USE_FAILOVER_IMAGE==0
#include "spd_addr.h"
-#include "cpu/amd/microcode/microcode.c"
-#include "cpu/amd/model_10xxx/update_microcode.c"
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
w83627hf_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
uart_init();
console_init();
- printk_debug("\n");
+ printk(BIOS_DEBUG, "\n");
/* Halt if there was a built in self test failure */
report_bist_failure(bist);
#endif
val = cpuid_eax(1);
- printk_debug("BSP Family_Model: %08x\n", val);
- printk_debug("*sysinfo range: ["); print_debug_hex32((u32)sysinfo); print_debug(","); print_debug_hex32((u32)sysinfo+sizeof(struct sys_info)); print_debug("]\n");
- printk_debug("bsp_apicid = %02x\n", bsp_apicid);
- printk_debug("cpu_init_detectedx = %08x\n", cpu_init_detectedx);
+ printk(BIOS_DEBUG, "BSP Family_Model: %08x\n", val);
+ printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
+ printk(BIOS_DEBUG, "bsp_apicid = %02x\n", bsp_apicid);
+ printk(BIOS_DEBUG, "cpu_init_detectedx = %08lx\n", cpu_init_detectedx);
/* Setup sysinfo defaults */
set_sysinfo_in_ram(0);
#if CONFIG_LOGICAL_CPUS==1
/* Core0 on each node is configured. Now setup any additional cores. */
- printk_debug("start_other_cores()\n");
+ printk(BIOS_DEBUG, "start_other_cores()\n");
start_other_cores();
post_code(0x37);
wait_all_other_cores_started(bsp_apicid);
post_code(0x38);
-#if FAM10_SET_FIDVID == 1
+#if SET_FIDVID == 1
msr = rdmsr(0xc0010071);
- printk_debug("\nBegin FIDVID MSR 0xc0010071 0x%08x 0x%08x\n", msr.hi, msr.lo);
+ printk(BIOS_DEBUG, "\nBegin FIDVID MSR 0xc0010071 0x%08x 0x%08x\n", msr.hi, msr.lo);
/* FIXME: The sb fid change may survive the warm reset and only
* need to be done once.*/
/* show final fid and vid */
msr=rdmsr(0xc0010071);
- printk_debug("End FIDVIDMSR 0xc0010071 0x%08x 0x%08x\n", msr.hi, msr.lo);
+ printk(BIOS_DEBUG, "End FIDVIDMSR 0xc0010071 0x%08x 0x%08x\n", msr.hi, msr.lo);
#endif
wants_reset = mcp55_early_setup_x();
}
if (wants_reset)
- printk_debug("mcp55_early_setup_x wanted additional reset!\n");
+ printk(BIOS_DEBUG, "mcp55_early_setup_x wanted additional reset!\n");
post_code(0x3B);
/* It's the time to set ctrl in sysinfo now; */
- printk_debug("fill_mem_ctrl()\n");
+ printk(BIOS_DEBUG, "fill_mem_ctrl()\n");
fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
post_code(0x3D);
- printk_debug("enable_smbus()\n");
+ printk(BIOS_DEBUG, "enable_smbus()\n");
enable_smbus();
- post_code(0x3E);
- memreset_setup();
post_code(0x40);
- printk_debug("raminit_amdmct()\n");
+ printk(BIOS_DEBUG, "raminit_amdmct()\n");
raminit_amdmct(sysinfo);
post_code(0x41);
- printk_debug("\n*** Yes, the copy/decompress is taking a while, FIXME!\n");
+ printk(BIOS_DEBUG, "\n*** Yes, the copy/decompress is taking a while, FIXME!\n");
post_cache_as_ram(); // BSP switch stack to ram, copy then execute LB.
post_code(0x43); // Should never see this post code.
}
-
-#endif
projects / coreboot.git / blobdiff