/*
- * This file is part of the LinuxBIOS project.
+ * This file is part of the coreboot project.
*
* Copyright (C) 2005 Tyan
* (Written by Yinghai Lu <yhlu@tyan.com> for Tyan)
smbus_dev = dev_find_device(0x1022, 0x746b, 0);
if (!smbus_dev)
die("SMBus controller not found\n");
- printk_debug("SMBus controller found\n");
+ printk(BIOS_DEBUG, "SMBus controller found\n");
/* Find the ADT7463 device. */
path.type = DEVICE_PATH_I2C;
- path.u.i2c.device = 0x2d;
+ path.i2c.device = 0x2d;
adt7463 = find_dev_path(smbus_dev->link, &path);
if (!adt7463)
die("ADT7463 not found\n");
- printk_debug("ADT7463 found\n");
+ printk(BIOS_DEBUG, "ADT7463 found\n");
/* Set all fans to 'Fastest Speed Calculated by All 3 Temperature
* Channels Controls PWMx'.
/* Set TACH measurements to normal (1/second). */
result = smbus_write_byte(adt7463, 0x78, 0xf0);
- printk_debug("ADT7463 properly initialized\n");
+ printk(BIOS_DEBUG, "ADT7463 properly initialized\n");
}
static void dummy_noop(device_t dummy)
max = root_dev_scan_bus(root, max);
- printk_debug("scan_root_bus ok\n");
+ printk(BIOS_DEBUG, "scan_root_bus ok\n");
/* The following is a little silly. We need a hook into the boot
* process *after* the ADT7463 device has been initialized. So we
link_i = root->links;
if (link_i >= MAX_LINKS) {
- printk_debug("Reached MAX_LINKS, not configuring ADT7463");
+ printk(BIOS_DEBUG, "Reached MAX_LINKS, not configuring ADT7463");
return max;
}
root->link[link_i].link = link_i;
root->links++;
path.type = DEVICE_PATH_PNP;
- path.u.pnp.port = 0;
- path.u.pnp.device = 0;
+ path.pnp.port = 0;
+ path.pnp.device = 0;
dummy = alloc_dev(&root->link[link_i], &path);
dummy->ops = &dummy_operations;
dev->ops = &mainboard_operations;
}
-#if CONFIG_CHIP_NAME == 1
-struct chip_operations mainboard_tyan_s2881_ops = {
+struct chip_operations mainboard_ops = {
CHIP_NAME("Tyan S2881 Mainboard")
.enable_dev = enable_dev,
};
-#endif