#include <stdint.h>
+#include <stdlib.h>
#include <device/pci_def.h>
#include <arch/io.h>
#include <device/pnp_def.h>
#include <arch/romcc_io.h>
#include <arch/hlt.h>
-#include "pc80/serial.c"
-#include "console/console.c"
-#include "lib/ramtest.c"
+#include <console/console.h>
#include "cpu/x86/bist.h"
#include "cpu/x86/msr.h"
#include <cpu/amd/lxdef.h>
#include <cpu/amd/geode_post_code.h>
#include "southbridge/amd/cs5536/cs5536.h"
-
-#define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
-
+#include <spd.h>
#include "southbridge/amd/cs5536/cs5536_early_smbus.c"
#include "southbridge/amd/cs5536/cs5536_early_setup.c"
#include "superio/winbond/w83627hf/w83627hf_early_serial.c"
+#define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
+
static inline int spd_read_byte(unsigned device, unsigned address)
{
- return smbus_read_byte(device, address);
+ return smbus_read_byte(device, address);
}
#define ManualConf 0 /* Do automatic strapped PLL config */
#define PLLMSRhi 0x00001490 /* manual settings for the PLL */
#define PLLMSRlo 0x02000030
-#define DIMM0 0xA0
-#define DIMM1 0xA2
+
#include "northbridge/amd/lx/raminit.h"
#include "northbridge/amd/lx/pll_reset.c"
#include "northbridge/amd/lx/raminit.c"
#include "lib/generic_sdram.c"
#include "cpu/amd/model_lx/cpureginit.c"
#include "cpu/amd/model_lx/syspreinit.c"
+#include "cpu/amd/model_lx/msrinit.c"
-static void msr_init(void)
-{
- msr_t msr;
- /* Setup access to the MC for under 1MB. Note MC not setup yet. */
- msr.hi = 0x24fffc02;
- msr.lo = 0x10010000;
- wrmsr(CPU_RCONF_DEFAULT, msr);
-
- msr.hi = 0x20000000;
- msr.lo = 0xfff00;
- wrmsr(MSR_GLIU0 + 0x20, msr);
-
- msr.hi = 0x20000000;
- msr.lo = 0xfff00;
- wrmsr(MSR_GLIU1 + 0x20, msr);
-}
-
-static void mb_gpio_init(void)
-{
- /* Early mainboard specific GPIO setup */
-}
-
-void cache_as_ram_main(void)
+void main(unsigned long bist)
{
post_code(0x01);
static const struct mem_controller memctrl [] = {
- {.channel0 = {(0xa<<3)|0, (0xa<<3)|1}}
+ {.channel0 = {DIMM0, DIMM1}}
};
SystemPreInit();
*/
cs5536_disable_internal_uart();
w83627hf_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
- mb_gpio_init();
uart_init();
console_init();
+ /* Halt if there was a built in self test failure */
+ report_bist_failure(bist);
+
pll_reset(ManualConf);
- cpuRegInit();
+ cpuRegInit(0, DIMM0, DIMM1, DRAM_TERMINATED);
sdram_initialize(1, memctrl);
print_err("POST 02\n");
__asm__("wbinvd\n");
print_err("Past wbinvd\n");
- /* we are finding the return does not work on this board. Explicitly call the label that is
+ /* we are finding the return does not work on this board. Explicitly call the label that is
* after the call to us. This is gross, but sometimes at this level it is the only way out
*/
void done_cache_as_ram_main(void);
done_cache_as_ram_main();
}
-