#include "lib/delay.c"
#include "cpu/x86/lapic/boot_cpu.c"
#include "northbridge/amd/amdk8/reset_test.c"
-#include "superio/ite/it8712f/it8712f_early_serial.c"
-#include <usbdebug.h>
+#include "superio/ite/it8712f/early_serial.c"
#include <spd.h>
#include "cpu/x86/mtrr/earlymtrr.c"
#include "cpu/x86/bist.h"
#include "northbridge/amd/amdk8/setup_resource_map.c"
-#include "southbridge/amd/rs690/rs690_early_setup.c"
-#include "southbridge/amd/sb600/sb600_early_setup.c"
-#include "northbridge/amd/amdk8/debug.c" /* After sb600_early_setup.c! */
+#include "southbridge/amd/rs690/early_setup.c"
+#include "southbridge/amd/sb600/early_setup.c"
+#include "northbridge/amd/amdk8/debug.c" /* After sb600/early_setup.c! */
-/* CAN'T BE REMOVED! memory bus reset hook for some broken amd k8 boards. */
-static void memreset(int controllers, const struct mem_controller *ctrl)
-{
-}
-
-/* called in raminit_f.c */
-static inline void activate_spd_rom(const struct mem_controller *ctrl)
-{
-}
+static void memreset(int controllers, const struct mem_controller *ctrl) { }
+static void activate_spd_rom(const struct mem_controller *ctrl) { }
-/*called in raminit_f.c */
static inline int spd_read_byte(u32 device, u32 address)
{
return smbus_read_byte(device, address);
/* Nothing special needs to be done to find bus 0 */
/* Allow the HT devices to be found */
enumerate_ht_chain();
-
sb600_lpc_port80();
/* sb600_pci_port80(); */
}
- if (bist == 0) {
+ if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
- }
enable_rs690_dev8();
sb600_lpc_init();
/* Pistachio used a FPGA to enable serial debug instead of a SIO
* and it doesn't require any special setup. */
- uart_init();
-
-#if CONFIG_USBDEBUG
- sb600_enable_usbdebug(0);
- early_usbdebug_init();
-#endif
console_init();
/* Check to see if processor is capable of changing FIDVID */
/* otherwise it will throw a GP# when reading FIDVID_STATUS */
cpuid1 = cpuid(0x80000007);
- if( (cpuid1.edx & 0x6) == 0x6 ) {
-
+ if ((cpuid1.edx & 0x6) == 0x6) {
/* Read FIDVID_STATUS */
msr=rdmsr(0xc0010042);
printk(BIOS_DEBUG, "begin msr fid, vid: hi=0x%x, lo=0x%x\n", msr.hi, msr.lo);
/* show final fid and vid */
msr=rdmsr(0xc0010042);
printk(BIOS_DEBUG, "end msr fid, vid: hi=0x%x, lo=0x%x\n", msr.hi, msr.lo);
-
} else {
printk(BIOS_DEBUG, "Changing FIDVID not supported\n");
}