* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
-#define ASSEMBLY 1
-#define __PRE_RAM__
-
-#define RAMINIT_SYSINFO 1
-#define K8_SET_FIDVID 1
-#define QRANK_DIMM_SUPPORT 1
-#if CONFIG_LOGICAL_CPUS==1
-#define SET_NB_CFG_54 1
-#endif
-
#define RC0 (6<<8)
#define RC1 (7<<8)
-#define DIMM0 0x50
-#define DIMM1 0x51
-
-#define ICS951462_ADDRESS 0x69
#define SMBUS_HUB 0x71
#include <stdint.h>
#include <device/pnp_def.h>
#include <arch/romcc_io.h>
#include <cpu/x86/lapic.h>
-#include "option_table.h"
-#include "pc80/mc146818rtc_early.c"
-#include "pc80/serial.c"
-#include "arch/i386/lib/console.c"
-
-#define post_code(x) outb(x, 0x80)
-
+#include <pc80/mc146818rtc.h>
+#include <console/console.h>
+#include <spd.h>
#include <cpu/amd/model_fxx_rev.h>
#include "northbridge/amd/amdk8/raminit.h"
#include "cpu/amd/model_fxx/apic_timer.c"
#include "lib/delay.c"
-
#include "cpu/x86/lapic/boot_cpu.c"
#include "northbridge/amd/amdk8/reset_test.c"
-#include "superio/ite/it8718f/it8718f_early_serial.c"
-
-#include "cpu/amd/mtrr/amd_earlymtrr.c"
+#include "superio/ite/it8718f/early_serial.c"
+#include "cpu/x86/mtrr/earlymtrr.c"
#include "cpu/x86/bist.h"
-
#include "northbridge/amd/amdk8/setup_resource_map.c"
+#include "southbridge/amd/rs780/early_setup.c"
+#include "southbridge/amd/sb700/sb700.h"
+#include "southbridge/amd/sb700/smbus.h"
+#include "northbridge/amd/amdk8/debug.c" /* After sb700/early_setup.c! */
-#include "southbridge/amd/rs780/rs780_early_setup.c"
-#include "southbridge/amd/sb700/sb700_early_setup.c"
-#include "northbridge/amd/amdk8/debug.c" /* After sb700_early_setup.c! */
-
-/* CAN'T BE REMOVED! crt0.S will use it. I don't know WHY!*/
-static void memreset(int controllers, const struct mem_controller *ctrl)
-{
-}
-
-/* called in raminit_f.c */
-static inline void activate_spd_rom(const struct mem_controller *ctrl)
-{
-}
+static void memreset(int controllers, const struct mem_controller *ctrl) { }
+static void activate_spd_rom(const struct mem_controller *ctrl) { }
-/*called in raminit_f.c */
static inline int spd_read_byte(u32 device, u32 address)
{
- return smbus_read_byte(device, address);
+ return do_smbus_read_byte(SMBUS_IO_BASE, device, address);
}
#include "northbridge/amd/amdk8/amdk8.h"
#include "northbridge/amd/amdk8/coherent_ht.c"
#include "lib/generic_sdram.c"
#include "resourcemap.c"
-
#include "cpu/amd/dualcore/dualcore.c"
-
-#include "cpu/amd/car/copy_and_run.c"
#include "cpu/amd/car/post_cache_as_ram.c"
-
#include "cpu/amd/model_fxx/init_cpus.c"
-
#include "cpu/amd/model_fxx/fidvid.c"
-
#include "northbridge/amd/amdk8/early_ht.c"
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
/* Nothing special needs to be done to find bus 0 */
/* Allow the HT devices to be found */
enumerate_ht_chain();
-
- /* sb700_lpc_port80(); */
- sb700_pci_port80();
+ /* sb7xx_51xx_lpc_port80(); */
+ sb7xx_51xx_pci_port80();
}
- if (bist == 0) {
+ if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
- }
enable_rs780_dev8();
- sb700_lpc_init();
+ sb7xx_51xx_lpc_init();
it8718f_enable_serial(0, CONFIG_TTYS0_BASE);
- uart_init();
+
console_init();
/* Halt if there was a built in self test failure */
/* run _early_setup before soft-reset. */
rs780_early_setup();
- sb700_early_setup();
+ sb7xx_51xx_early_setup();
/* Check to see if processor is capable of changing FIDVID */
/* otherwise it will throw a GP# when reading FIDVID_STATUS */
cpuid1 = cpuid(0x80000007);
- if( (cpuid1.edx & 0x6) == 0x6 ) {
-
+ if ((cpuid1.edx & 0x6) == 0x6) {
/* Read FIDVID_STATUS */
msr=rdmsr(0xc0010042);
printk(BIOS_DEBUG, "begin msr fid, vid: hi=0x%x, lo=0x%x\n", msr.hi, msr.lo);
/* show final fid and vid */
msr=rdmsr(0xc0010042);
printk(BIOS_DEBUG, "end msr fid, vid: hi=0x%x, lo=0x%x\n", msr.hi, msr.lo);
-
} else {
printk(BIOS_DEBUG, "Changing FIDVID not supported\n");
}
printk(BIOS_DEBUG, "needs_reset=0x%x\n", needs_reset);
if (needs_reset) {
- print_info("ht reset -\r\n");
+ print_info("ht reset -\n");
soft_reset();
}
allow_all_aps_stop(bsp_apicid);
/* It's the time to set ctrl now; */
- printk(BIOS_DEBUG, "sysinfo->nodes: %2x sysinfo->ctrl: %2x spd_addr: %2x\n",
+ printk(BIOS_DEBUG, "sysinfo->nodes: %2x sysinfo->ctrl: %p spd_addr: %p\n",
sysinfo->nodes, sysinfo->ctrl, spd_addr);
fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
rs780_before_pci_init();
- sb700_before_pci_init();
+ sb7xx_51xx_before_pci_init();
post_cache_as_ram();
}
projects / coreboot.git / blobdiff