libpayload: fix wborder()

[coreboot.git] / payloads / libpayload / Config.in

diff --git a/payloads/libpayload/Config.in b/payloads/libpayload/Config.in
index f3606ae5757beeb221b2ffb12c66e1bce2132c66..fe534001bb40725b557bc917b13750ab412a390c 100644 (file)
--- a/payloads/libpayload/Config.in
+++ b/payloads/libpayload/Config.in
@@ -73,6 +73,10 @@ config TARGET_POWERPC
 
 endchoice
 
+config MEMMAP_RAM_ONLY
+       bool "Only consider RAM entries in memory map for further processing"
+       default n
+
 config MULTIBOOT
        bool "Multiboot header support"
        depends on TARGET_I386
@@ -134,9 +138,9 @@ config SERIAL_ACS_FALLBACK
          displaying a couple of other special graphics characters.  The
          ACS characters generally look good on screen, but can be difficult
          to cut and paste from a terminal window to a text editor.
-       
+
          Say 'y' here if you want to always use plain ASCII characters to
-         approximate the appearance of ACS characters on the serial port 
+         approximate the appearance of ACS characters on the serial port
          console.
 
 config VIDEO_CONSOLE
@@ -194,12 +198,12 @@ config RTC_PORT_EXTENDED_VIA
          For recent chipsets with 256 NVRAM bytes, you have to access the
          upper 128 bytes (128-255) using two different I/O ports,
          usually 0x72/0x73.
-       
+
          On some chipsets this can be a different set of ports, though.
          The VIA VT8237R for example only recognizes the ports 0x74/0x75
          for accessing the high 128 NVRAM bytes (as seems to be the case for
          multiple VIA chipsets).
-       
+
          If you want to read or write CMOS bytes on computers with one of
          these chipsets, say 'y' here.
 
@@ -224,13 +228,18 @@ config USB_OHCI
        help
          Select this option if you are going to use USB 1.1 on an AMD based
          system.
-         NOTE: This option is not (fully) implemented yet
 
 config USB_EHCI
        bool "Support for USB EHCI controllers"
        depends on USB
        help
          Select this option if you want to use USB 2.0
+
+config USB_XHCI
+       bool "Support for USB xHCI controllers"
+       depends on USB
+       help
+         Select this option if you want to use USB 3.0
          NOTE: This option is not (fully) implemented yet
 
 config USB_HID