-print "Reading from the IRAM again..."
-data_re = cmdREAD(0x00030000, len(data_wr))
-print "Received data:", data_re, "Checksum:", last_checksum
-"""
-
-"""
-# see whats in the iram at the moment
-data_wr = []
-print "Reading from the IRAM..."
-data_re = cmdREAD(0x00030000, 0x10000-4)
-print "Received data:", data_re, "Checksum:", last_checksum
-"""
-
-"""
-# see whats in the dram at the moment
-data_wr = []
-print "Reading from the DRAM..."
-data_re = cmdREAD(0x0002C000, 0x10000-0xC000-4)
-print "Received data:", data_re, "Checksum:", last_checksum
-"""
-
-"""
-# blank the iram
-data_wr = []
-for i in range(0, 0x10000-4):
- value = 0
- data_wr.append(value)
-
-print "Writing", data_wr, "to the IRAM..."
-cmdWRITE(0x00030000, len(data_wr), data_wr)
-print "Received Checksum:", last_checksum
-print
-"""
-
-"""
-# blank the dram
-data_wr = []
-for i in range(0, 0x10000-0xC000-4):
- value = 0
- data_wr.append(value)
-
-print "Writing", data_wr, "to the DRAM..."
-cmdWRITE(0x0002C000, len(data_wr), data_wr)
-print "Received Checksum:", last_checksum
-print
-"""
-
-
-"""
-S006000066756AB4
-S20E0F40009B000D4ECFF11601E0FFF6
-S214148000FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF67
-S804000000FB
-
-NOP = 0x9fa0
-"""
-# write some data in the iram and try to execute it
-# ATTENTION: before running this, run a program on the board (e.g. flashdemo).
-# the bytecode will be executed after copied into iram, however it won't stop
-# and executes the stuff after it in the iram. after a powerreset this can be
-# randomcrap and this could be very dangerous! so pay attention please
-data_wr =[0x9B,0x00,0x0D,0x4e,0xcf,0xf1,0x16,0x01,0xe0,0xff,0xf6,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0xe0,
- 0xcb,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,
- 0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0,0x9f,0xa0]
-print "Writing", data_wr, "to the IRAM..."
-cmdWRITE(0x00030000, len(data_wr), data_wr)
-print "Received Checksum:", last_checksum