if BOARD_LIPPERT_HURRICANE_LX

config BOARD_SPECIFIC_OPTIONS # dummy
	def_bool y
	select ARCH_X86
	select CPU_AMD_GEODE_LX
	select NORTHBRIDGE_AMD_LX
	select SOUTHBRIDGE_AMD_CS5536
	select SUPERIO_ITE_IT8712F
	select HAVE_PIRQ_TABLE
	select PIRQ_ROUTE
	select UDELAY_TSC
	# Board is equipped with a 1 MB SPI flash, however, due to limitations
	# of the IT8712F Super I/O, only the top 512 KB are directly mapped.
	select BOARD_ROMSIZE_KB_512

config MAINBOARD_DIR
	string
	default lippert/hurricane-lx

config MAINBOARD_PART_NUMBER
	string
	default "Hurricane-LX"

config IRQ_SLOT_COUNT
	int
	default 8

config BOARD_OLD_REVISION
	bool "Board is old pre-3.0 revision"
	default n
	select POWER_BUTTON_DEFAULT_DISABLE
	help
	  Look on the bottom side for a number like 406-0001-30.  The last 2
	  digits state the PCB revision (3.0 in this example).  For 2.0 or older
	  boards choose Y, for 3.0 and newer say N.

	  Old revision boards need a jumper shorting the power button to
	  power on automatically.  You may enable the button only after this
	  jumper has been removed.  New revision boards are not restricted
	  in this way, and always have the power button enabled.

config POWER_BUTTON_FORCE_ENABLE
	def_bool y if !BOARD_OLD_REVISION

config ONBOARD_UARTS_RS485
	bool "Switch on-board serial ports to RS485"
	default n
	help
	  If selected, both on-board serial ports will operate in RS485 mode
	  instead of RS232.

endif # BOARD_LIPPERT_HURRICANE_LX