##
## This file is part of the coreboot project.
##
## Copyright (C) 2007 Rudolf Marek <r.marek@assembler.cz>
##
## This program is free software; you can redistribute it and/or modify
## it under the terms of the GNU General Public License v2 as published by
## the Free Software Foundation.
##
## This program is distributed in the hope that it will be useful,
## but WITHOUT ANY WARRANTY; without even the implied warranty of
## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
## GNU General Public License for more details.
##
## You should have received a copy of the GNU General Public License
## along with this program; if not, write to the Free Software
## Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301 USA
##

uses HAVE_MP_TABLE
uses HAVE_PIRQ_TABLE
uses USE_FALLBACK_IMAGE
uses HAVE_FALLBACK_BOOT
uses HAVE_HARD_RESET
uses IRQ_SLOT_COUNT
uses HAVE_OPTION_TABLE
uses CONFIG_MAX_CPUS
uses CONFIG_MAX_PHYSICAL_CPUS
uses CONFIG_LOGICAL_CPUS
uses CONFIG_IOAPIC
uses CONFIG_SMP
uses FALLBACK_SIZE
uses ROM_SIZE
uses ROM_SECTION_SIZE
uses ROM_IMAGE_SIZE
uses ROM_SECTION_SIZE
uses ROM_SECTION_OFFSET
uses CONFIG_ROM_PAYLOAD
uses CONFIG_ROM_PAYLOAD_START
uses PAYLOAD_SIZE
uses _ROMBASE
uses XIP_ROM_SIZE
uses XIP_ROM_BASE
uses STACK_SIZE
uses HEAP_SIZE
# uses USE_OPTION_TABLE
# uses CONFIG_LB_MEM_TOPK
uses HAVE_ACPI_TABLES
uses LB_CKS_RANGE_START
uses LB_CKS_RANGE_END
uses LB_CKS_LOC
uses MAINBOARD
uses MAINBOARD_PART_NUMBER
uses MAINBOARD_VENDOR
uses MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID
uses MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID
uses COREBOOT_EXTRA_VERSION
uses _RAMBASE
uses CONFIG_GDB_STUB
uses CROSS_COMPILE
uses CC
uses HOSTCC
uses OBJCOPY
uses TTYS0_BAUD
uses TTYS0_BASE
uses TTYS0_LCS
uses DEFAULT_CONSOLE_LOGLEVEL
uses MAXIMUM_CONSOLE_LOGLEVEL
uses MAINBOARD_POWER_ON_AFTER_POWER_FAIL
uses CONFIG_CONSOLE_SERIAL8250
uses HAVE_INIT_TIMER
uses CONFIG_GDB_STUB
uses CONFIG_CHIP_NAME
uses CONFIG_CONSOLE_VGA
uses CONFIG_PCI_ROM_RUN
# bx_b001- uses K8_HW_MEM_HOLE_SIZEK
uses K8_HT_FREQ_1G_SUPPORT
uses USE_DCACHE_RAM
uses DCACHE_RAM_BASE
uses DCACHE_RAM_SIZE
uses DCACHE_RAM_GLOBAL_VAR_SIZE
uses CONFIG_USE_INIT
uses ENABLE_APIC_EXT_ID
uses APIC_ID_OFFSET
uses LIFT_BSP_APIC_ID
uses HT_CHAIN_UNITID_BASE
uses HT_CHAIN_END_UNITID_BASE
# bx_b001- uses K8_SB_HT_CHAIN_ON_BUS0
uses SB_HT_CHAIN_UNITID_OFFSET_ONLY
# bx_b005+
uses SB_HT_CHAIN_ON_BUS0
uses CONFIG_COMPRESSED_PAYLOAD_NRV2B
uses CONFIG_COMPRESSED_PAYLOAD_LZMA
uses CONFIG_USE_PRINTK_IN_CAR

default ROM_SIZE = 512 * 1024
default FALLBACK_SIZE = 256 * 1024
default HAVE_FALLBACK_BOOT = 1
default HAVE_HARD_RESET = 0
default HAVE_PIRQ_TABLE = 0
default IRQ_SLOT_COUNT = 11	# FIXME?
default HAVE_MP_TABLE = 1
default HAVE_OPTION_TABLE = 0	# FIXME
# Move the default coreboot CMOS range off of AMD RTC registers.
default LB_CKS_RANGE_START = 49
default LB_CKS_RANGE_END = 122
default LB_CKS_LOC = 123
default CONFIG_SMP = 1
default CONFIG_MAX_CPUS = 2
default CONFIG_MAX_PHYSICAL_CPUS = 1
default CONFIG_LOGICAL_CPUS = 1
default HAVE_ACPI_TABLES = 1
# default CONFIG_CHIP_NAME = 1

# 1G memory hole
# bx_b001- default K8_HW_MEM_HOLE_SIZEK = 0x100000

# Opteron K8 1G HT support
default K8_HT_FREQ_1G_SUPPORT = 1

# HT Unit ID offset, default is 1, the typical one.
default HT_CHAIN_UNITID_BASE = 0x0

# Real SB Unit ID, default is 0x20, mean don't touch it at last.
# default HT_CHAIN_END_UNITID_BASE = 0x0

# Make the SB HT chain on bus 0, default is not (0).
# bx_b001- default K8_SB_HT_CHAIN_ON_BUS0 = 2

# bx_b005+ make the SB HT chain on bus 0.
default SB_HT_CHAIN_ON_BUS0 = 1

# Only offset for SB chain?, default is yes(1).
default SB_HT_CHAIN_UNITID_OFFSET_ONLY = 0

default CONFIG_CONSOLE_VGA = 1		# Needed for VGA.
default CONFIG_PCI_ROM_RUN = 1		# Needed for VGA.
default USE_DCACHE_RAM = 1
default DCACHE_RAM_BASE = 0xcc000
default DCACHE_RAM_SIZE = 0x4000
default DCACHE_RAM_GLOBAL_VAR_SIZE = 0x01000
default CONFIG_USE_INIT = 0
default ENABLE_APIC_EXT_ID = 0
default APIC_ID_OFFSET = 0x10
default LIFT_BSP_APIC_ID = 0
default CONFIG_IOAPIC = 1
default MAINBOARD_VENDOR = "ASUS"
default MAINBOARD_PART_NUMBER = "A8V-E SE"
default MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID = 0x1043
# default MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID = 0x1234	# FIXME
default ROM_IMAGE_SIZE = 64 * 1024
default STACK_SIZE = 8 * 1024
default HEAP_SIZE = 256 * 1024
# More 1M for pgtbl.
# default CONFIG_LB_MEM_TOPK = 2048
default _RAMBASE = 0x00004000
# default USE_OPTION_TABLE = !USE_FALLBACK_IMAGE
default CONFIG_ROM_PAYLOAD = 1
default CC = "$(CROSS_COMPILE)gcc -m32"
default HOSTCC = "gcc"
default CONFIG_GDB_STUB = 0
default CONFIG_USE_PRINTK_IN_CAR = 1
default CONFIG_CONSOLE_SERIAL8250 = 1
default TTYS0_BAUD = 115200
default TTYS0_BASE = 0x3f8
default TTYS0_LCS = 0x3		# 8n1
default DEFAULT_CONSOLE_LOGLEVEL = 8
default MAXIMUM_CONSOLE_LOGLEVEL = 8
default MAINBOARD_POWER_ON_AFTER_POWER_FAIL = "MAINBOARD_POWER_ON"
end