#include <console/console.h>
#include <device/device.h>
#include <device/smbus.h>
#include <device/pci.h>
#include <device/pci_ids.h>
#include <device/pci_ops.h>
#include <cpu/x86/msr.h>
#include "chip.h"

#define ADM1026_DEVICE 0x2d /* Either 0x2c or 0x2d or 0x2e */
#define ADM1026_REG_CONFIG1 0x00
#define CFG1_MONITOR     0x01
#define CFG1_INT_ENABLE  0x02
#define CFG1_INT_CLEAR   0x04
#define CFG1_AIN8_9      0x08
#define CFG1_THERM_HOT   0x10
#define CFT1_DAC_AFC     0x20
#define CFG1_PWM_AFC     0x40
#define CFG1_RESET       0x80
#define ADM1026_REG_CONFIG2 0x01
#define ADM1026_REG_CONFIG3 0x07

static void adm1026_enable_monitoring(device_t dev);

static void adm1026_init(device_t dev)
{
	if (dev->enabled && dev->path.type == DEVICE_PATH_I2C)
	{
		if(ops_smbus_bus(get_pbus_smbus(dev))) {
			if( dev->bus->dev->path.type == DEVICE_PATH_I2C) smbus_set_link(dev); // it is under mux 
			adm1026_enable_monitoring(dev);
		}
		
	}

}
static void adm1026_enable_monitoring(device_t dev)
{
        int result;
        result = smbus_read_byte(dev, ADM1026_REG_CONFIG1);

        result = (result | CFG1_MONITOR) & ~(CFG1_INT_CLEAR | CFG1_RESET);
        result = smbus_write_byte(dev, ADM1026_REG_CONFIG1, result);

        result = smbus_read_byte(dev, ADM1026_REG_CONFIG1);
        if (!(result & CFG1_MONITOR)) {
                printk_debug("ADM1026: monitoring would not enable");
        }
}
static void adm1026_noop(device_t dummy)
{
}

static struct device_operations adm1026_operations = {
        .read_resources   = adm1026_noop,
        .set_resources    = adm1026_noop,
        .enable_resources = adm1026_noop,
        .init             = adm1026_init,
};

static void enable_dev(struct device *dev)
{
	dev->ops = &adm1026_operations;
}

struct chip_operations drivers_i2c_adm1026_ops = {
	CHIP_NAME("adm1026")
	.enable_dev = enable_dev, 
};