3 uses USE_FALLBACK_IMAGE
4 uses HAVE_FALLBACK_BOOT
12 uses MAINBOARD_PART_NUMBER
13 uses LINUXBIOS_EXTRA_VERSION
22 uses ROM_SECTION_OFFSET
23 uses CONFIG_ROM_STREAM_START
24 uses CONFIG_COMPRESSED_ROM_STREAM_LZMA
36 uses DEFAULT_CONSOLE_LOGLEVEL
37 uses MAXIMUM_CONSOLE_LOGLEVEL
38 uses CONFIG_CONSOLE_SERIAL8250
39 uses CONFIG_UDELAY_TSC
40 uses CONFIG_PCI_ROM_RUN
41 uses CONFIG_CONSOLE_VGA
42 uses CONFIG_MAX_PCI_BUSES
45 ## ROM_SIZE is the size of boot ROM that this board will use.
46 default ROM_SIZE = 256*1024
51 default CONFIG_PCI_ROM_RUN=0
52 default CONFIG_CONSOLE_VGA=0
55 ## Build code for the fallback boot
57 default HAVE_FALLBACK_BOOT=1
62 default HAVE_MP_TABLE=0
65 ## Use TSC for udelay.
67 default CONFIG_UDELAY_TSC=1
70 ## Build code to reset the motherboard from linuxBIOS
72 default HAVE_HARD_RESET=1
75 ## Build code to export a programmable irq routing table
77 default HAVE_PIRQ_TABLE=1
78 default IRQ_SLOT_COUNT=5
82 ## Build code to load acpi tables
84 default HAVE_ACPI_TABLES=1
88 ## Build code to export a CMOS option table
90 default HAVE_OPTION_TABLE=1
93 ### LinuxBIOS layout values
96 ## ROM_IMAGE_SIZE is the amount of space to allow linuxBIOS to occupy.
97 default ROM_IMAGE_SIZE = 65536
98 default FALLBACK_SIZE = 131072
101 ## Use a small 8K stack
103 default STACK_SIZE=0x2000
106 ## Use a small 16K heap
108 default HEAP_SIZE=0x4000
111 ## Only use the option table in a normal image
113 #default USE_OPTION_TABLE = !USE_FALLBACK_IMAGE
114 default USE_OPTION_TABLE = 0
116 default _RAMBASE = 0x00004000
118 default CONFIG_ROM_STREAM = 1
121 ## The default compiler
123 default CROSS_COMPILE=""
124 default CC="$(CROSS_COMPILE)gcc -m32"
128 ## Set this to the max PCI bus number you
129 ## would ever use for PCI config IO.
130 ## Setting this number very high will make
131 ## pci_locate_device take a long time when
132 ## it can't find a device.
134 default CONFIG_MAX_PCI_BUSES = 5