2 * This file is part of the coreboot project.
4 * Copyright (C) 2007 AMD
5 * Written by Yinghai Lu <yinghailu@amd.com> for AMD.
7 * This program is free software; you can redistribute it and/or modify
8 * it under the terms of the GNU General Public License as published by
9 * the Free Software Foundation; either version 2 of the License, or
10 * (at your option) any later version.
12 * This program is distributed in the hope that it will be useful,
13 * but WITHOUT ANY WARRANTY; without even the implied warranty of
14 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
15 * GNU General Public License for more details.
17 * You should have received a copy of the GNU General Public License
18 * along with this program; if not, write to the Free Software
19 * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
25 #define RAMINIT_SYSINFO 1
27 #define K8_ALLOCATE_IO_RANGE 1
29 #define QRANK_DIMM_SUPPORT 1
31 #if CONFIG_LOGICAL_CPUS==1
32 #define SET_NB_CFG_54 1
35 //used by init_cpus and fidvid
36 #define K8_SET_FIDVID 1
37 //if we want to wait for core1 done before DQS training, set it to 0
38 #define K8_SET_FIDVID_CORE0_ONLY 1
40 #if CONFIG_K8_REV_F_SUPPORT == 1
41 #define K8_REV_F_SUPPORT_F0_F1_WORKAROUND 0
44 #define DBGP_DEFAULT 7
48 #include <device/pci_def.h>
49 #include <device/pci_ids.h>
51 #include <device/pnp_def.h>
52 #include <arch/romcc_io.h>
53 #include <cpu/x86/lapic.h>
54 #include "option_table.h"
55 #include "pc80/mc146818rtc_early.c"
57 #include "pc80/serial.c"
58 #include "arch/i386/lib/console.c"
59 #if CONFIG_USBDEBUG_DIRECT
60 #include "southbridge/nvidia/mcp55/mcp55_enable_usbdebug_direct.c"
61 #include "pc80/usbdebug_direct_serial.c"
63 #include "lib/ramtest.c"
65 #include <cpu/amd/model_fxx_rev.h>
67 #include "southbridge/nvidia/mcp55/mcp55_early_smbus.c"
68 #include "northbridge/amd/amdk8/raminit.h"
69 #include "cpu/amd/model_fxx/apic_timer.c"
70 #include "lib/delay.c"
72 #include "cpu/x86/lapic/boot_cpu.c"
73 #include "northbridge/amd/amdk8/reset_test.c"
74 #include "superio/ite/it8716f/it8716f_early_serial.c"
75 #include "superio/ite/it8716f/it8716f_early_init.c"
77 #include "cpu/x86/bist.h"
79 #include "northbridge/amd/amdk8/debug.c"
81 #include "cpu/amd/mtrr/amd_earlymtrr.c"
83 #include "northbridge/amd/amdk8/setup_resource_map.c"
85 #define SERIAL_DEV PNP_DEV(0x2e, IT8716F_SP1)
86 #define GPIO_DEV PNP_DEV(0x2e, IT8716F_GPIO)
88 #include "southbridge/nvidia/mcp55/mcp55_early_ctrl.c"
90 static void memreset_setup(void)
94 static void memreset(int controllers, const struct mem_controller *ctrl)
98 static inline void activate_spd_rom(const struct mem_controller *ctrl)
103 static inline int spd_read_byte(unsigned device, unsigned address)
105 return smbus_read_byte(device, address);
108 #include "northbridge/amd/amdk8/amdk8_f.h"
109 #include "northbridge/amd/amdk8/coherent_ht.c"
111 #include "northbridge/amd/amdk8/incoherent_ht.c"
113 #include "northbridge/amd/amdk8/raminit_f.c"
115 #include "lib/generic_sdram.c"
117 #include "resourcemap.c"
119 #include "cpu/amd/dualcore/dualcore.c"
122 #define MCP55_USE_NIC 1
123 #define MCP55_USE_AZA 1
125 #define MCP55_PCI_E_X_0 0
127 #define MCP55_MB_SETUP \
128 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+37, 0x00, 0x68,/* GPIO38 PCI_REQ3 */ \
129 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+38, 0x00, 0x68,/* GPIO39 PCI_GNT3 */ \
130 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+39, 0x00, 0x68,/* GPIO40 PCI_GNT2 */ \
131 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+40, 0x00, 0x68,/* GPIO41 PCI_REQ2 */ \
132 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+59, 0x00, 0x60,/* GPIP60 FANCTL0 */ \
133 RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+60, 0x00, 0x60,/* GPIO61 FANCTL1 */
135 #include "southbridge/nvidia/mcp55/mcp55_early_setup_ss.h"
136 #include "southbridge/nvidia/mcp55/mcp55_early_setup_car.c"
138 #include "cpu/amd/car/copy_and_run.c"
140 #include "cpu/amd/car/post_cache_as_ram.c"
142 #include "cpu/amd/model_fxx/init_cpus.c"
144 #include "cpu/amd/model_fxx/fidvid.c"
146 #include "southbridge/nvidia/mcp55/mcp55_enable_rom.c"
147 #include "northbridge/amd/amdk8/early_ht.c"
150 static void sio_setup(void)
157 byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b);
159 pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte);
161 dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0);
163 pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword);
165 dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4);
167 pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword);
171 void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
173 static const uint16_t spd_addr [] = {
174 (0xa<<3)|0, (0xa<<3)|2, 0, 0,
175 (0xa<<3)|1, (0xa<<3)|3, 0, 0,
176 #if CONFIG_MAX_PHYSICAL_CPUS > 1
177 (0xa<<3)|4, (0xa<<3)|6, 0, 0,
178 (0xa<<3)|5, (0xa<<3)|7, 0, 0,
182 struct sys_info *sysinfo = (CONFIG_DCACHE_RAM_BASE + CONFIG_DCACHE_RAM_SIZE - CONFIG_DCACHE_RAM_GLOBAL_VAR_SIZE);
185 unsigned bsp_apicid = 0;
188 if (!cpu_init_detectedx && boot_cpu()) {
189 /* Nothing special needs to be done to find bus 0 */
190 /* Allow the HT devices to be found */
192 enumerate_ht_chain();
196 /* Setup the mcp55 */
201 bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
204 pnp_enter_ext_func_mode(SERIAL_DEV);
205 /* The following line will set CLKIN to 24 MHz, external */
206 pnp_write_config(SERIAL_DEV, IT8716F_CONFIG_REG_CLOCKSEL, 0x11);
207 tmp = pnp_read_config(SERIAL_DEV, IT8716F_CONFIG_REG_SWSUSP);
208 /* Is serial flash enabled? Then enable writing to serial flash. */
210 pnp_write_config(SERIAL_DEV, IT8716F_CONFIG_REG_SWSUSP, tmp | 0x10);
211 pnp_set_logical_device(GPIO_DEV);
212 /* Set Serial Flash interface to 0x0820 */
213 pnp_write_config(GPIO_DEV, 0x64, 0x08);
214 pnp_write_config(GPIO_DEV, 0x65, 0x20);
215 /* We can get away with not resetting the logical device because
216 * it8716f_enable_dev(SERIAL_DEV, CONFIG_TTYS0_BASE) will do that.
219 it8716f_enable_dev(SERIAL_DEV, CONFIG_TTYS0_BASE);
220 pnp_exit_ext_func_mode(SERIAL_DEV);
222 setup_mb_resource_map();
226 /* Halt if there was a built in self test failure */
227 report_bist_failure(bist);
230 #if CONFIG_USBDEBUG_DIRECT
231 mcp55_enable_usbdebug_direct(DBGP_DEFAULT);
232 early_usbdebug_direct_init();
235 printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
237 print_debug("bsp_apicid="); print_debug_hex8(bsp_apicid); print_debug("\r\n");
239 #if CONFIG_MEM_TRAIN_SEQ == 1
240 set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
242 setup_coherent_ht_domain(); // routing table and start other core0
244 wait_all_core0_started();
245 #if CONFIG_LOGICAL_CPUS==1
246 // It is said that we should start core1 after all core0 launched
247 /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
248 * So here need to make sure last core0 is started, esp for two way system,
249 * (there may be apic id conflicts in that case)
252 wait_all_other_cores_started(bsp_apicid);
255 /* it will set up chains and store link pair for optimization later */
256 ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn
258 #if K8_SET_FIDVID == 1
262 msr=rdmsr(0xc0010042);
263 print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\r\n");
269 enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
271 init_fidvid_bsp(bsp_apicid);
273 // show final fid and vid
276 msr=rdmsr(0xc0010042);
277 print_debug("end msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\r\n");
282 needs_reset |= optimize_link_coherent_ht();
283 needs_reset |= optimize_link_incoherent_ht(sysinfo);
284 needs_reset |= mcp55_early_setup_x();
286 // fidvid change will issue one LDTSTOP and the HT change will be effective too
288 print_info("ht reset -\r\n");
291 allow_all_aps_stop(bsp_apicid);
293 //It's the time to set ctrl in sysinfo now;
294 fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
300 //do we need apci timer, tsc...., only debug need it for better output
301 /* all ap stopped? */
302 // init_timer(); // Need to use TMICT to synconize FID/VID
304 sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
306 post_cache_as_ram(); // bsp swtich stack to ram and copy sysinfo ram now